For the metal roof industry
Specifically designed for retrofit roof vents with a pre-installed metal base
Available in EPDM rubber
The overall height is 1/4” (6mm) with A flexible aluminium base that allows the flashing to conform to any panel configuration and most roof pitches regardless of vent location.
Square or Rectangle: 4” to 12” (101 to 355mm)
Base: 24” (609mm)
For roof vents with a Pre-Installed metal base for the Metal Roofing Industry
The RVA is made of EPDM rubber for maximum resistance to weathering due to the zone and ultraviolet light.
The RVA opening is 11-3/4” X 11-3/4” (298 X 298mm) with the base measuring at 24” (609mm)
The overall height is 1/4” (6mm) with A flexible aluminium base that allows the flashing to conform to any panel configuration and most roof pitches, regardless of vent location.
For pipes that penetrate through a residential roof that requires a wrap-around installation.
Made of an EPDM rubber or High-Temp silicone.
A built-in 20° pitch for slanted roofs.
Fits: Closed up to 5-3/8” (0 up to 136mm) pipes.
Base: 15” (381mm).
10 PCS/BOX
Roof pipe flashings for the metal roof industry. Perfect for sealing pipes and cables, and ideal for watertight sealing around installation elements/ducts penetrating the roof slope (i.e., ventilation pipes, solar ducts, chimney flues, electric cables and wires or other elements passing through the roof slope).
Specifically designed to seal pipes or vents that require a wrap-around product, or for hard-to-reach installations.
5 PCS/BOX
Designed for the metal roof Industry
Made of black or gray EPDM rubber or high-temp red silicone
Designed to seal existing pipes/vents
5 PCS/BOX